7 Accessing System Information iPocket232 User Guide
23-CML000293 iPocket232 Inc. 64
The following table lists all possible error codes that may appear in the system log.
Table 7.4: System Log Error Messages
the i/o request has been scheduled but not completed
no more i/o paths are available
requested operation was not supported by the driver
the provided i/o buffer was not valid
requested operation cannot be done in current state
too many connections of this type are already open
socket connection type (“domain”) is unknown
socket protocol type is unknown
“socket has already been bound to another port” Check that the port
number is available for use. Change configuration if necessary.
requested port number is already in use
requested address was not valid for operation
operation requires bound port but socket is unbound
device is not ready for the requested operation
cannot open connection because socket is already connected
operation requires connected socket but not connected
“data message is too big for transport type” Usually occurs with UDP
mode.
requested operation would break this thread -- try later
incoming data corruption has been detected
no data is available for this operation
“no route available from this host to destination host” Check the IP
address of the host. Change configuration if necessary.
storage device can accept no more data
requested option is not available
To Next Page
Loading...