Precor Experience 700 line Series - Lift Motor Replacement; Lift Motor Calibration

2. Set the Take-up roller into the left and right mounting brackets.
3. Connect the power cord and switch the ON/OFF circuit breaker to ON.
4. Center and square the running belt between the Drive and Take-up rollers. Tension to
specification and verify tracking, see "Running Belt Tension and Tracking Adjustment"
on page55.
5. Reinstall the left and right Landing Trim covers, see "Covers and Panels Replacement"
on page70 and hood cover, see "Covers and Panels Replacement" on page70,.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 138
6 Replacement Procedures
Take-up Roller Replacement