2. Place the extension tube into the lift platform mounting bracket and secure using the
hitch pin and clevis pin. It may be necessary to slightly rotate the extension tube to align
the clevis pin mounting holes. If the extension tube has been rotated during or after it
was removed, recalibrate the lift motor prior to installation, see "Lift Motor Calibration"
on pageî61.
Remove supports and lower the treadmill
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 162
6 Replacement Procedures
Lift Platform Replacement
To Next Page
Loading...
