Precor move beyond S3.45 User Manual

S3.45 Assembly and Maintenance Guide
page 18
1 2 3 4 5 6
9. Assemble Leg Curl
Weight Stack
A. Place two Guide Rods into the large holes on the
Leg Curl side of the Main Base.
B. Place one Weight Cushion on each Guide Rod and
allow it to slide down to the top of the Main Base.
C. Apply one tube of lubricant to each Guide Rod.
Avoid getting lubricant on your clothing or on other
parts of the machine.
D. Add the five 15-lb weights, the ten 10-lb weights,
and the five 5-lb weights. Note the tab location for
weight stickers (you will attach the stickers later).
Hold your finger over the plastic bushing in each
weight to prevent the bushing from popping out.
CAUTION: The weights are heavy! Handle
them carefully so as not to drop them or injure
yourself. Pick up and place one weight at a time
onto the Guide Rods. Have someone hold the
Guide Rods in place while you slide the
weights on the stack.
E. Place the Cap Plate on the Guide Rods with
the hole facing toward you. Allow it to slide onto
the Weight Stack.
F. Insert the retainer pins of the Center Bracket into
the Guide Rods, making sure the longest end of
the bracket points in the direction of the Chest
Press. Attach the Center Bracket to the Top Frame
using
two 3-inch bolts
four washers
two locknuts
Wrench tighten.
Step 9. Assemble Leg Curl Weight Stack
Guide Rods (2)
Weight
Cushions (2)
D
B
A
E
Cap Plate
Main Base
5 - 5-lb Weights
10 - 10-lb Weights
5 - 15-lb Weights
D
Rear Upright
2 - 3" bolts
4 - washers
2 - locknuts
Top Frame
F
Retainer Pins
Center Bracket
F
Front

Precor move beyond S3.45 Specifications

General

Brand	Precor
Model	move beyond S3.45
Category	Fitness Equipment
Language	English