Precor move beyond S3.45 - Page 25

S3.45 Assembly and Maintenance Guide
page 25
1 2 3 4 5 6
D. Attach the lower section of the Backpad to the
lower hole of the right Backpad Support Tube using
two 3-inch bolt
two washers
Finger tighten.
E. Attach the Leg Curl Handle to the holes at the top of
the Backpad Support Tubes using
two 1-inch bolts
two washers
F. Attach the Backpad Support Tubes to the top of the
Backpad using
two 3-inch bolts
two washers
G. Attach the top portion of the Leg Curl Handle to the
holes at the top and bottom of the Headrest using
two 1¼-inch bolts
two washers
Note: Handles point down when fastened.
H. Wrench tighten all bolts from this step.
I. Attach the Calf Raise Block to the Leg Curl Seat
Upright using
one 4¼-inch bolt
two washers
one locknut
Step 13. Assemble Leg Curl Seat, Continued
D
G
2 - 1¼" bolts
2 - washers
2 - 3" bolt
2 - washers
Leg Curl
Handle
Backpad
I
Calf Raise Block
1 - 4¼" bolt
2 - washers
1 - locknut
Backpad Support
Tubes
Leg Curl Seat Upright
Headrest
E
2 - 1" bolts
2 - washers
F
2 - 3" bolts
2 - washers