Precor SPINNER CHRONO POWER User Manual

1. Center the stabilizer attachment bar into the rear stabilizer weldment bracket.
2. Position the rear stabilizer onto the frame weldment and secure using the two 6 mm
hex key stabilizer mounting bolts (2x) and washers (2x) , torque to 15.6 ft-lbs (21
N•m).
CAUTION:Do not over tighten fasteners. The bolt heads can snap off if over
tightened.
3. Install the two rear stabilizer leveling feet.
4. Return bike to the upright position.
5. Make sure the bike is level and setting firmly on the floor, see "Bike Leveling Adjust-
ment" on page39.
6. Verify bike operation per the "Operation Verification Checklist" on page14 and return
to service.
See Also
"Front Stabilizer Replacement" on page137
"Bike Leveling Adjustment" on page39
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 142
5 Replacement Procedures
Stabilizer Replacement

Precor SPINNER CHRONO POWER Specifications

General

Brand	Precor
Model	SPINNER CHRONO POWER
Category	Exercise Bike
Language	English