The sell-powered Spinner
®
Chrono
1
™ bike models use the Spinner® Chrono™ consoles
and the non-powered models use the Spinning
®
Studio Consoles.
"Spinner® Chrono™ Console" on page177 "Spinning® Studio Console" on page185
3) Review the Error Log for any detected codes
Always review the Error Log when troubleshooting an issue. The error log will contain any
triggered error code event and related information. Then use the Error Code Troubleshoot-
ing Guide to help resolve the reported error code. Also, when calling Precor customer ser-
vice for assistance, refer to the Error Log and report any logged error codes to the customer
support representative.
Refer to the Error Code Troubleshooting Guide for error code descriptions and repair inform-
ation.
IMPORTANT: Error code descriptions and troubleshooting information can be found
in the Error Code Troubleshooting Guide, see Error Code Guide Troubleshooting
Guide.
Note:Not all failures trigger an error event code. Many issues are purely mech-
anical in nature and therefore cannot trigger an error event code.
4) Verify (reproduce) the issue.
Operate the unit in normal user mode and attempt to reproduce the reported failure.
Determine if the error is a repeatable or intermittent type failure. Make note of any additional
observations (noises, vibrations, etc.) that occur at the time of the failure which may then be
used to help resolve the issue.
Note: It is important to keep in mind that some issues are weight (load) related.
You may need to test the unit at minimum and maximum load limits to reproduce
1
Spinner® Chrono™ Power bike.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 144
6 Troubleshooting
Basic Steps
To Next Page
Loading...
Need help?
General
