the failure.
5) Perform hardware validation service tests
On Chrono consoles, access the service mode and run any related tests that might help isol-
ate the cause of the issue, see "Spinner® Chrono™ Console" on page177. These tests will
also help to identify good and failed components. Resolve any resulting failures.
6) Verify that there are no new error codes
After correcting the issue, use the equipment from minimum to maximum resistance and
speed ranges. Then stop pedaling and verify that the Error Log does not contain any new
error codes. . This will verify that the original error codes issues are fixed and that there are
no new error code issues.
Note:If there is no logged error codes and the issue persists, you will need to use
observable and audible indicators to identify the source of the failure. Also make
sure that there are no related service bulletins that may resolve the issue. Go to
Precor Connect website and browse the list of current service bulletins.
7) Verify service bulletins
Go to the Precor Connect website and browse the list of machine service bulletins and tech-
tips. Incorporate any missing service bulletin repairs and in particular any bulletins that may
fix the current failure.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 145
6 Troubleshooting
Basic Steps
To Next Page
Loading...
Need help?
General
