PROLEC PME200 - Low Limit Setting - Using Current Lowest Point

562200-000, Issue 1.2, December 2015
45 of 62
8.4.3 Low Limit Setting - using Current Lowest Point
Set the limit using the lowest point of the machine.
Move equipment to required low
limit and press this button
Once a limit is set, the internal alarm will sound and the RED LED
will light if the equipment exceeds the current limit. Always check
that the current limit activates at the set point. The restriction cannot be de-
activated if in the alarm state. Observe the operational limitations given in
section 4.
To set the low limit using the
machine, move the equipment
to the desired low height, and
press the ‘current lowest point’
button. A confirmation box will
appear reporting the value set.
Press the TICK button to con-
tinue.