ProMinent
®
Page 23
7.1 Measured variables pH and redox
7.1.1 Menu overview: measured variable pH
NOTE
The following menu is only an example.
The displays can vary depending upon the general settings.
DMT settings
pH
param. measurement
zero point. = -0.1 mV
slope = 60.30 mV/pH
probe check: on
zero point = -0.1 mV
slope = 60.30 mV/pH
probe check: on
meas. val. = 7.12 pH
param. output signal
output: meas. value
4 mA: 2.00 pH
20 mA: 12.00 pH
output: meas. value
4 mA: 2.00 pH
20 mA: 12.00 pH
general settings
DMTaW090P10E0220
2.1.06
device type
!! correct probe ??
type = pH
DMTaW090P10E0220
general settings
language
DMTaW090P10E0220
E = english
param. temperature
input: sensor
unit: ˚C
pH
12.5 mA 21.0 ˚C
7.12
= Request access code
(if activated by the user)
input: sensor
unit: ˚C
offset = 0.00 ˚C
meas. val. = 21.00 ˚C
general settings
change
access code = 5000
free access
BA_DM_163_03_08_GB.p65 26.03.2008, 10:20 Uhr23
To Next Page
Loading...
