Procedures MP.11-R Installation and Management
Configuration Restore
173
Configuration Restore
You can restore the configuration of the unit by downloading a configuration file. The configuration file contains the
configuration information of a unit.
To download a configuration file through the Web Interface:
1. Set up the TFTP server as described in TFTP Server Setup.
2. Access the unit as described in Logging in to the Web Interface.
3. Click Commands > Download tab.
4. Fill in the following details:
• Server IP Address: <IP address TFTP server>
• File Name: <configuration file name>
• File Type: Config
• File Operation: Download
5. Click OK to start the file transfer.
The unit downloads the configuration file. The TFTP server program should show download activity after a few seconds.
When the download is complete and the system rebooted, the configuration is restored.
To Next Page
Loading...
Need help?
General
