Configuration MP.11-R Installation and Management
Filtering Parameters
106
Broadcast Protocol Filtering
Click Configure > Filtering > Broadcast Protocol to deny specific IP broadcast, IPX broadcast, and multicast traffic.
Click Edit Table Entries to display an editable window such as the following. You can configure whether this traffic must
be blocked for Ethernet to wireless, wireless to Ethernet, or both.
IP Access Table Filtering
Click Configure > Filtering > IP Access Table to limit in-band management access to the IP addresses or range of IP
addresses specified in the table.
For example, 172.17.23.0/255.255.255.0 allows access from all wireless stations with an IP address in the 172.17.23.xxx
range.
This feature applies to all management services (SNMP, HTTP, and CLI), except for CLI management over the serial
port.