Technical Specifications MP.11-R Installation and Management
Hardware Specifications
225
Hardware Specifications
Software Features
Category Specification
Processor 166 MHz Motorola 8241 processor
Memory Flash: 8 MB; RAM: 16 MB
Category Specification
Key Features • WORP protocol
• Dynamic Data Rate Selection (Configured on BSU)
• Transmit Power Control
• Antenna Alignment (CLI output)
• Integrity Check for Software Upload
• Mobility with Auto-scanning
• QoS Support; up to 8 classes of service, up to 8 service flows per class (BSU only)
• Satellite Density
• Enhanced Dynamic Frequency Selection (Configured on BSU)
• Redundancy
• Spanning Tree (802.1D)
Bridging and Routing • Bridge (802.1d)
• IP/ RIPv1 (RFC 1058)
• IP/ RIPv2 (RFC 1388)
• CIDR (RFC 1519)
• ICMP (RFC 792)
• IP (RFC 791)
• ARP (RFC 826)
Filtering • Ethernet protocol (Ethertype)
• Static MAC
• Storm threshold
• IP address
• Broadcast protocol
• Intra-cell blocking (Configured on BSU)
Services • DHCP Server (RFC 2131)
• DHCP Client (RFC 2131)
• Bi-Directional Bandwidth Control
• NAT (RFC 3022) (Configured on SU)
• DHCP Relay (RFC 2131) (Configured on SU)
VLAN • 802.1Q (Configured on BSU)
Security Features • Critical feature support via WORP for secure long-range wireless deployments in
unlicensed frequency spectrum
• MD5 (embedded in WORP) authentication between BSU and SU
• Filter based on packet information such as unicast/multicast/ broadcast MAC or IP
• MAC Authentication (Configured on BSU)
• Secure “over the air encryption” with WEP, WEP+, and AES, and AES-CCB
• RADIUS MAC Access Control (Configured on BSU)
• RADIUS (RFC 2138)
• Intra-cell blocking to allow the BSU to act as the central policy enforcer for SU to SU
communications
To Next Page
Loading...
Need help?
General
