Basic Management MP.11-R Installation and Management
General Configuration Settings
50
General Configuration Settings
• System Status: The Status tab showing the system status is displayed automatically when you log into the Web
interface. It is also the default window displayed when you click Status on the left side of the window. See System
Status.
• System Configuration: The System Configuration window lets you change the unit’s country, system name, location
name, and so on (see the window to the right). The Country selection is required to enable the correct radio
parameters. The other details help distinguish this device from other devices, and let you know whom to contact in
case of problems. See System Parameters for more information.
• IP Configuration: The IP Configuration window lets you change the unit’s IP parameters. These settings differ
between Routing and Bridge mode. See Network Parameters for more information.
• Interface Configuration: The Interface configuration pages let you change the Ethernet and Wireless parameters.
The Wireless tab is displayed by default when you click the Interfaces tab.
– Ethernet: To configure the Ethernet interface, click Configure > Interfaces > Ethernet. You can set the
Configuration parameter from this tab for the type of Ethernet transmission. The recommended setting is
auto-speed auto-duplex. See Interface Parameters for more information.
– Wireless: To configure the wireless interface, click Configure > Interfaces > Wireless. For BSUs, the wireless
interface can be placed in either WORP Base or WORP Satellite mode (selected from the Interface Type drop-
down box). SUs can be placed only in WORP Satellite mode. (See Interface Parameters for more information.)
• VLAN Configuration: To configure BSU VLAN parameters, click Configure followed by the VLAN tab; the BSU
Table tab is displayed. Click the SUs’ Table
tab to configure SU VLAN parameters. Virtual LAN (VLAN)
implementation in the Tsunami MP.11 products lets the BSU and SU be used in a VLAN-aware network and processes
IEEE 802.1Q VLAN-tagged packets. Network resources behind the BSU and SU can be assigned to logical groups.
See VLAN Parameters for more information.
To Next Page
Loading...
Need help?
General
