MP.11-R Installation and Management
59
6
Configuration
This chapter describes configuring the unit’s settings using the unit’s Web Interface.
Click Configure to access configuration settings.
The following topics are discussed in this section:
• System Parameters
• Network Parameters
• Interface Parameters
• SNMP Parameters
• Management Parameters
• Security Parameters
• Filtering Parameters
• Intra-Cell Blocking (BSU Only; Bridge Mode Only)
• VLAN Parameters
• QoS Configuration for a Management Station
• Syslog Parameters
• RIP Parameters (Routing Mode Only)
• NAT (SU Only; Routing Mode Only)
Help and Exit buttons also appear on each page of the Web interface; click Help to access online help; click Exit to exit
the application.
For an introduction to the basics of management, see Basic Management.
System Parameters
The System configuration page lets you change the unit’s System Name, Location, Contact name, E-mail address
and Phone number. These details help you distinguish the particular device from other devices and let you know whom
to contact in case you experience problems.
Click Configure > System; the following window is displayed.
To Next Page
Loading...
Need help?
General
