Procedures MP.11-R Installation and Management
Image File Download with the Bootloader
178
• Parity: None
5. Disconnect and reconnect power to reset the unit; the terminal program displays Power On Self Test (POST)
messages.
6. When the “Sending Traps to SNMP manager periodically” message is displayed (after about 30 seconds), press
the ENTER key.
7. The command prompt is displayed; enter the following commands
:
set ipaddr <IP address nit>
set ipsubmask <subnet mask>
set ipaddrtype static
set tftpipaddr <IP address TFTP server>
set tftpfilename <image file name>
set ipgw <gateway IP address>
reboot
For example:
set ipaddr 10.0.0.12
set ipsubmask 255.255.255.0
set ipaddrtype static
set tftpipaddr 10.0.0.20
set tftpfilename image.bin
set ipgw 10.0.0.30
reboot
The unit reboots and downloads the image file. The TFTP server program should show download activity after a few
seconds. When the download is complete, the unit is ready for configuration.
To access the unit, see Logging in to the Web Interface. Note that the IP configuration in normal operation differs from the
IP configuration of the Boot Loader.
To Next Page
Loading...
Need help?
General
