System Overview MP.11-R Installation and Management
Changing Basic Configuration Information
38
dBm or less. For 4954-R models that have an integrated flat-panel antenna, a TPC of -9 dB must be used to
comply with FCC Part 90 regulations.
CAUTION: To ensure proper operation on 4954-R models, the maximum TPC attenuation is -9 db. Values from -10 dB
to -18 dB are not usable.
NOTE: You can see your unit’s current output power for the selected frequency in the event log. The event log shows the
selected power for all data rates, so you must look up the relevant data rate to determine the actual power level.
NOTE: This feature only lets you decrease your output power; you cannot increase your output power beyond the
maximum the radio allows for your frequency and data rate.
See System Parameters to configure Country. See Interface Parameters to configure Transmit Power Control.
To Next Page
Loading...
Need help?
General
