page 14
Industrial Power Corruptor Manual Rev 1.00
terminal block. Failure to use a wire adaptor will result in poor
clamping to the conductor and dangerous access to high voltage
wires/surfaces.
As a standard practice, mount wire adaptors in any terminal
blocks that do not have conductors inserted.
This will prevent
finger access to un-used terminal block contacts.
When you insert larger conductors directly into the terminal
blocks, O-rings or similar protective insulating devices should
be used to ensure that it is impossible to touch bare conductors
or terminal block contacts.
absolute-emc.com
Phone:703-774-7505
info@absolute-emc.com
To Next Page
Loading...