page 31
Industrial Power Corruptor Manual Rev 1.00
3.3.7 Motor drive for circuit breaker (optional)
This convenient option lets you close the circuit breaker from the
front of the IPC, avoiding the requirement to reach over to the back of
the IPC (near high voltage connections) in order to manually turn the
breaker on.
The 3-pin circular connector next to the Instrument Power AC inlet
is the electrical connection point for this assembly
. Retrofitting this
assembly is as simple as aligning the circuit breaker lever and motor
operator guide (important; see instructions below), attaching the motor
operator to the rear panel using the 4 screws provided, and plug its
cable into the circular connector on the rear panel.
The motor operator assembly is locked in operating position using
the screw and cap nut on the rear tabs. If access the circuit breaker
lever is required for any reason, the motor operator does not need to be
removed from the rear panel. Removing the screw and cap nut, and
pull down on the outer tab. The motor operator will hinge open. However,
care must be taken when re-closing this assembly, as it is very likely
that the circuit breaker lever and motor operator guide may not be
aligned. If the motor operator is closed in the wrong alignment, it may
burn out the internal motor.
The correct procedure in mounting/re-closing the motor operator
assembly is as follows:
1. Manually (or using the front panel Circuit Breaker Off button if
the IPC is running) move the circuit breaker lever fully to the OFF
position.
2. Using a flat head screwdriver, turn the slotted shaft of the motor
operator until the arrow on the white lever guide aligns with the OFF
arrow on the back plate.
3. Attach the motor operator to the rear panel using the 4 #8-32 x
3/8" screws provided (or close and lock in place the hinged motor
operator assembly if it is already attached).
3.3.7 Impulse generator connectors (optional)
The high-frequency, high-energy impulse generator is a future
option.
absolute-emc.com
Phone:703-774-7505
info@absolute-emc.com
To Next Page
Loading...