Pulsar 22 User Manual

Pulsar Model 22 User Manual
Page 28
Starting the measurement
To start a measurement session, hold the Reader with the Infrared link aimed at the
Infrared link window of the dosemeter. The Reader and dosemeter can be up to 50cm
apart. Press the Run key. The Reader will program the start time and date into the
dosemeter.
The Reader will show the status of the communication between the dosemeter and the
Reader on the display.
Do not move the Reader away from the dosemeter until
the indicators show in the dosemeter.
An indicator will show in the badge window for up to 2
seconds to show that it has received the message and
started running. If an indicator does not show then try
again.
When the dosemeter is running (and making a measurement), the indicator will flash
quickly to indicate that the unit is operating.
The dosemeter can now be left on the wearer. The wearer should be instructed to avoid
knocking the meter as this can affect the Peak measurements and add to the noise
dose.
Using the RK1 Keyfob Remote Control
The dosemeter can also be started using the RK1 Keyfob Remote Control. Point the
Keyfob at the dosemeter Infrared window and press the Run button. The dosemeter will
start in the same way as described above for the Reader unit.
starting....ok
Press the Run
button to start
the dosemeter
Indicatorflasheswhen
thedosemeteris
running

Pulsar 22 Specifications

General

Type	Laser Distance Meter
Accuracy	± 1.5 mm
Display	LCD with backlight
Power Supply	2 x AAA batteries
Operating Temperature	0°C to 40°C
Resolution	1 mm