Pulsar Model 22 User Manual
Page 5
Preface
Guidelines for Safe & Efficient Use
Please read all sections of this manual before attempting to use the
instrument.
Warnings
This symbol is used throughout the manual to indicate that special
attention should be taken and any instructions followed carefully.
Information covered in these sections relates to operations that are vital to
the efficient use of the instrument.
Calibration of the dosemeter
The dosemeter should be calibrated before each measurement. It is also
possible to carry out a second calibration check at the end of the
measurement before the data is downloaded.
Please refer to Appendix 3 dosemeter Calibration on page 63 for details of the
recommended calibration procedure for the dosemeter.
dosemeter Configuration
The MODEL 22 dosemeter can be configured to meet the requirements of
many different Occupational Noise and Industrial Hygiene Regulations and
Guidelines.
The Dual Channel capability allows the dosemeter to be used, for example, where there
is a requirement to measure noise exposure in accordance with both OSHA and ISO
standards.
Please ensure that the MODEL 22R Reader Unit is configured for the correct functions
and parameters before making measurements with the dosemeter.
The Pulsar AnalyzerPlus software can also be used to configure the dosemeter and
Reader unit to meet these requirements.
dosemeter Battery Performance
The NiMH rechargeable battery within the MODEL 22 dosemeter is designed to
be recharged using the supplied battery chargers. Do not attempt to charge
the dosemeter battery by any other means.
Before the first use
Before the dosemeters are used for the first time ensure that the units are
allowed to fully charge which may take up to 3 hours.
To Next Page
Loading...
