Pyronix ENFORCER V11 - Page 45

45
ENFORCER V11 PROGRAMMING GUIDE
MENU OPTIONS CLEAN START 2020 CLEAN START 2000
EOL Mode DR [1] DR [1]
Input Response 300ms 300ms
INSTALL ZEMs
ZEM Address No [0] (for all ZEM addresses) No [0] (for all ZEM addresses)
CHANGE OUTPUTS
Endstation Outputs
BELL O/P Siren Any [0014] Siren Any [0014]
STB O/P Strobe Any [0016] Strobe Any [0016]
PGM O/P Not Used [0000] Not Used [0000]
ZEM Outputs
ZEM Address
Output 1-4 Unused [00] Unused [00]
Wireless Bells
BELL O/P Siren Any [0014] Siren Any [0014]
STB O/P Strobe Any [0016] Strobe Any [0016]
Output Module Outputs
OP Mod Address
OP Mod Installed No [0] No [0]
Keypad Outputs
Address [0]-[3]
Output 1 Unused [0000] Unused [0000]
Reader Outputs
Address [1]-[3]
Output 1 Unused [0000] Unused [0000]
User Outputs?
User Output Type Latched [0] Latched [0]
User Output Name _ _
ASSIGN KEYPADS/READERS
Address Address [0]: Keypad [1]
Addresses [1]-[3]: Unused [0] Address [0]: Keypad [1]
Addresses [1]-[3]: Unused [0]
Set Point Sets [ABCD] [ABCD]
Set Point Unsets [ABCD] [ABCD]
Set Point In [ABCD] [ABCD]
Set Point Description
Enter Name Device 0 Device 0
Enter Location