To Next Page

To Previous Page

SETTING UP DMZ IN ROUTER 2

STEP 1. Login into Router 1 by putting

the IP of Router 1 into the Internet

Explorer browser, as in the example

shown in Picture 1-22 where the IP

address of Router 1 is 192.168.0.1

STEP 2. Find the status page on the

router settings that shows the WAN/

Internet IP address and write it down

this WAN IP address.

STEP 3. Log into the Router 2 by putting

the IP of Router 2 into the Internet

Explorer browser, as in example

shown in Picture 1-24 where the IP

address of Router 2 is 192.168.1.1

STEP 4. Find the DMZ page in the

router settings.

STEP 5. Enter the WAN IP for Router 1

into the DMZ page and enable DMZ.

NOTE! If you do not have a DMZ setting in the router, check to see if there

is a Bridge setting. If so, then use the Bridge setting instead of DMZ.

PICTURE 1-24

STEP 6. Save your changes.

You have forwarded the ports on the router to which the DVR is connected, to the IP address

of the DVR, and set the primary router to pass the connection to this router.

Q-See QT SERIES Remote Monitoring Setup Guide

Other manuals for Q-See QT SERIES