40
4.1 QT VIEW FOR APPLE IPAD AND IPHONE
PICTURE 4-1
Q-See QT View
Utilities
Released Apr 18, 2012
Q-See QT View HD
Utilities
Released May 10, 2012
FREE
FREE
For smartphones:
For tablets:
To launch QT View, simply tap on its icon in the app menu on your device.
SUPPORTED MODELS
At the time of this writing, the models of DVRs supported by the QT View apps are: QT2124,
QT426, QT428, QT454, QT474, QT446, QT4332, QT4516, QT4532, QT504, QT518, QT526,
QT528, QT536 and QT5116. Models not listed above, but purchased after May, 2012 should
also be compatible.
NOTE! Although the software needed to access your DVR is free, you will
need to have or create an iTunes or App Store account to proceed.
IMPORTANT! QT View for iPad and iPhone was being substancially upgraded
at the time of printing and many of the windows and steps may have changed
by the time you read this. Please visit the Q-See Knowledge Base at:
http://www.q-see.com/support for the most current instructions.
The QT View software allows you to remotely monitor your QT-series DVR (see list below)
using your mobile device and either a wireless or 3G/4G network. In addition to controlling
your system, you will be able to alter its settings and review video records saved on its hard
drive.
In order to monitor your system using your iPhone or iPad, you will need to install either the
Q-See QT View app for smartphones or Q-See QT View HD app if you’re using a tablet. These
are available for free through iTunes by searching for “Q-See.” Install either one as you would
any other application on your device.
Operation of both versions is largely the same with the major exception being that the HD
version for the iPad allows you to be able to view up to nine cameras simultaneously rather
than just four. Additionally, the viewing resolution is greater to take advantage of the tablet’s
higher resolution screen. Screen shots from both will be shown when there are differences,
but otherwise, most images will be from the iPad version.
To Next Page
Loading...
Need help?
General
