Qualigen FastPack IP System - Page 25

65000159 Rev. 008 (06/17) 15
Calibration Procedure
Calibration Procedure - Continued
Action
Instrument
Information
Illustration
Open analyzer door. Place
FastPack
®
IP on the door.
Align the pins on the door
with the holes in the
FastPack
®
IP.
“Insert Cal
Press Start”
It is only possible to align
the FastPack
®
IP in one
direction.
Close the analyzer door.
If the door is not closed,
the analyzer will not run.
Press the BLUE button.
“Insert Cal
Press Start”
The door will lock and the
analyzer will run the test.
“Processing
XX remaining”
The screen will display test
status and time remaining.