s
erver
p
roCessor
h
eaT
s
Inks
Processor Heat Sinks
Removing a Heat Sink
WARNING!
The heatsink remains hot after the system has been powered down. Allow
sufficient time to cool before handling system components.
Prerequisite:
♦ Remove the top cover. See Opening the Top Cover on page 1-6.
♦ Remove the air duct. See Removing the Air Duct on page 1-7.
1. Loosen the captive screws in a sequential order.
2. Remove the heat sink.
6
3
5
8 1 7 4
2
Figure 1-56: Removing the Heat Sink
3. To remove another heat sink, repeat the previous steps.
1-37