Communication Protocol CubiScan 125 Command Set
CubiScan 125 Service Manual 66
Location Id/City Code
This command is used to set the CubiScan 125 location identification. This data is stored in
permanent memory and need only be set once for each CubiScan 125.
5 1 Carriage Return Control (CR) 0Dh
61Line Feed Control(LF) 0Ah
Pos Len Description Type Range ASCII
Command Format
1 1 Start of Text Control (STX) 02h
2 1 Location Id. Command Alpha (L) 4Ch
3 6 City Code Alpha 000000-ZZZZZ
91End of Text Control(ETX) 03h
10 1 Carriage Return Control (CR) 0Dh
11 1 Line Feed Control (LF) 0Ah
Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Location Id. Command Alpha (L) 4Ch
3 1 Acknowledge Alpha (A) 41h
41End of Text Control(ETX) 03h
5 1 Carriage Return Control (CR) 0Dh
61Line Feed Control(LF) 0Ah
Negative Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Location Id. Command Alpha (L) 4Ch
31Neg. Acknowledge Alpha (N) 4Eh
41End of Text Control(ETX) 03h
5 1 Carriage Return Control (CR) 0Dh
61Line Feed Control(LF) 0Ah
Pos Len Description Type Range ASCII
To Next Page
Loading...
