EasyManua.ls Logo

Quectel EG25-G - IC & FCC Requirement; FCC Certification and RF Exposure Requirements

Quectel EG25-G
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LTE Module Series
EG25-G Hardware Design
EG25-G_Hardware_Design 100 /
100
13 IC & FCC Requirement
FCC Certification Requirements.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a
mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna
installation and operating configurations of this transmitter, including any applicable source-based
timeaveraging
duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion Requirements
of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user’s
body
and must not transmit simultaneously with any other antenna or transmitter.
3.A label with the following statements must be attached to the host end product: This device contains
FCC ID: XMR201903EG25G
4.To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, maximum antenna gain (including cable loss) must not exceed:
Operating Band
FCC Max Antenna GaindBi
IC Max Antenna GaindBi
GSM850
8.60
7.44
GSM1900
10.19
10.19
WCDMA BAND II
8.00
8.00
WCDMA BAND IV
5.00
5.00
WCDMA BAND V
9.42
8.26
LTE BAND 2
8.00
8.00
LTE BAND 4
5.00
5.00
LTE BAND 5
9.41
8.25
LTE BAND 7
8.00
8.00
LTE BAND 12
8.70
7.76
LTE BAND 13
9.16
8.09
LTE BAND 25
8.00
8.00
LTE BAND 26(814-824)
9.36
NA
LTE BAND 26(824-849)
9.41
8.25
LTE BAND 38
8.00
8.00
LTE BAND 41
8.00
8.00
5. This module must not transmit simultaneously with any other antenna or transmitter
6. The host end product must include a user manual that clearly defines operating requirements and
conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to the conditions 3 through 6 described above, a separate approval is
required to satisfy the SAR requirements of FCC Part 2.1093

Table of Contents

Related product manuals