1. FC20 module can only be used as a slave device.
2. When BT function is enabled on EG25-G module, PCM_SYNC and PCM_CLK pins are only used to
output signals.
3.
1)
Pads 24~27 are multiplexing pins used for audio design on EG25-G module and BT function on
FC20 module.
4. “*” means under development.
5. For more information about wireless connectivity interfaces, please refer to document [5].
3.14.1. WLAN Interface
EG25-G provides a low power SDIO 3.0 interface and control interface for WLAN design.
SDIO interface supports the SDR mode (up to 50MHz).
To Next Page
Loading...
