Radiolink Electronic Ltd
www.radiolink.com
There are two tool pop-ups after you click “OK”, one for make sure both your transmitter and receiver
are powered on and connected, and the motor of your drone does not have power and without
propellers.
And then click “OK” and move all RC sticks and switches to their extreme positions so the red bars hit the
limits.
If the red bars have not any change when you move the sticks, please check the receiver have connect
success or not, make sure the receiver (maybe R9DS) is output SBUS signal (the blue LED of R9DS means
work as SBUS signal). You can check if every corresponding red bar for every channel is work as below:
To Next Page
Loading...
Need help?
General
