RADWAG PS Series

12
Assembling a balance with reading interval 10 mg:
Remove the adhesive tape
protecting the mass spring on
one of the (2),
Assemble the weighing pan (1)
on the rubber mandrels (3),
After assembling the balance
components, check whether the
weighing pan is firmly placed on
the rubber mandrels.
Assembling a balance with reading interval 1 mg
Remove the adhesive tape
protecting the mass spring on
one of the (3),
Assemble the weighing pan (2)
on the rubber mandrels (4),
Assemble the glass anti-draft
shield (1) which is located on the
top cover of balance’s housing,
After assembling the balance
components, check whether the
weighing pan is firmly placed on
the rubber mandrels.