R&S 4200 Series - Remote Control Commands

R&S XU 4200 Remote Control Commands
6166.5368.02.01 6.18
6.3 Remote Control Commands
List of Remote Control Commands\List of Remote Control Commands "Radio".doc
The radio can be remotely controlled and monitored via its IP-interface.
Remote control is possible either via SNMP or the Rohde & Schwarz
GB2PP protocol and specified in a separate interface control document
(ICD).
The commands on the LAN interface between the radio and a VDL ground
computer are specified in a separate ICD.
Please contact your sales representative to obtain the ICD or MIB
documents.