R&S XU 4200
0.5 6166.5368.02.01
3.6.1.1
Behavior of the Main/Standby Configuration with Power On.......................................3.73
3.6.1.2 Behavior at Remote Control.........................................................................................3.75
3.6.1.3 Behavior in Case of Device Errors...............................................................................3.75
3.6.2 Cabling.........................................................................................................................3.76
3.6.3 Configuration................................................................................................................3.77
3.6.4 Limitations/Notes .........................................................................................................3.78
3.7 External Automatic Filters ........................................................................................3.79
3.7.1 Telsa External Automatic Filter....................................................................................3.79
3.7.1.1 Introduction/Overview ..................................................................................................3.79
3.7.1.2 Cabling.........................................................................................................................3.79
3.7.1.3 Configuration................................................................................................................3.80
3.7.1.4 Limitations/Notes .........................................................................................................3.80
3.7.2 R&S External Automatic Filter .....................................................................................3.80
3.7.2.1 Introduction/Overview ..................................................................................................3.80
3.7.2.2 Cabling.........................................................................................................................3.81
3.7.2.3 Configuration................................................................................................................3.81
3.7.2.4 Limitations/Notes .........................................................................................................3.81
3.8 In-Band Signaling ......................................................................................................3.82
3.8.1 Introduction/Overview ..................................................................................................3.82
3.8.2 Configuration................................................................................................................3.83
3.8.2.1 In-Band Signaling of PTT with Different Audio Tones .................................................3.83
3.8.2.2 In-Band Signaling of SQ with Different Audio Tones...................................................3.83
3.8.2.3 Audio In-Band Tones for RSSI Signaling.....................................................................3.83
3.9 RSSI Output Characteristic.......................................................................................3.84
3.9.1 Introduction/Overview ..................................................................................................3.84
3.9.2 Configuration................................................................................................................3.86
3.9.3 Limitations/Notes .........................................................................................................3.86
3.10 ACARS Mode (External Modem)...............................................................................3.87
3.10.1 Introduction/Overview ..................................................................................................3.87
3.10.2 Cabling.........................................................................................................................3.87
3.10.3 Configuration................................................................................................................3.88
3.10.4 Limitations/Notes .........................................................................................................3.89
3.11 Best Signal Selection ................................................................................................3.90
3.11.1 Introduction/Overview ..................................................................................................3.90
3.11.2 Cabling.........................................................................................................................3.91
3.11.3 Configuration................................................................................................................3.92
3.11.4 Limitations/Notes .........................................................................................................3.93
3.12 Audio via E1 Interface (Optional) .............................................................................3.94
3.12.1 Introduction/Overview ..................................................................................................3.94
3.12.2 Cabling.........................................................................................................................3.95
3.12.3 Configuration................................................................................................................3.95
3.12.4 Limitations/Notes .........................................................................................................3.96
3.12.5 Parallel Operation of the Analog and E1 Audio Interfaces ..........................................3.96
3.13 External Power Amplifiers ........................................................................................3.97
3.13.1 External Power Amplifier R&S VU220L.......................................................................3.97