Trying Out the Instrument
R&S
®
SMW200A
56Getting Started 1412.9220.02 ─ 21
Figure 6-5: Signal mapping to the global connectors
The "Global Connectors" dialog displays the current connectors configuration.
The settings are configurable, but in this example we use the default mapping.
3. Alternatively, select "Block Diagram > Baseband > Misc > Custom Digital
Mod", select the "> Trigger In" tab and select "Local Connector Settings" or
"Global Connector Settings".
In the current mapping, the three global connectors USER x on the front panel
are configured as follows:
● "Marker 1/2" are output at the USER 1/2 connectors
● The USER 3 connector is an input for the "Global Trigger 1" signal.
Check the front panel of the R&S SMW. The USER 1/2 LEDs are yellow; the
USER 3 LED is green.
Find the physical location of each connector
Use the built-in "Trigger Marker Clock > Show " function to display the loca-
tion of the selected connector. A blinking LED on the front/rear panel also
indicates the selected connector.
Triggering the Instrument with an External Signal
To Next Page
Loading...
