Rapid Shape Operating Instructions
Warning against dangerous UV radiation
Caution
Danger of injury from UV radiation!
Printing and calibration take place under the influence of UV radiation. UV radiation can
cause permanent damage to eyes and skin if exposed for a long time without suitable
protective equipment.
Therefore, during printing and calibration, work at the machine may only be performed
when wearing UV protection goggles.
• Printing process should be carried out when the protective hood is mainly closed.
• During calibration of the exposure unit, the UV protection goggles, supplied in the
scope of delivery, must be worn.
• The material reservoir may only be used when it’s filled with sufficient amount of
material.
• It’s recommended to wear the UV protection goggles during any operation at the
machine.
Warning against hand-related injuries
Caution
Danger of injury to hands due to moving parts!
The machine consists of accessible moving parts which can cause light hand injuries from
bruising and trapping. There is a risk of bruising and trapping due to moving of the building
platform. Only personnel instructed in the machine may operate the machine.
For this reason, the respective warnings must be observed and adhered to when working at the machine.
• During printing process and manual moving of the building platform, no fingers or
hands are allowed to be located in or inserted into the machine.
Warning against environmental influences
Caution
The machine’s electrical as well as mechanical components are only configured for certain
environmental influences. Non-observance of the prescribed environmental conditions can
cause damages to the machine.
For this reason, the respective warnings must be observed and adhered to before commissioning and
during operation.
• Protect the machine against humidity, dripping water and splash water.
• Do not place any filled objects, such as drinks for example, in the immediate vicinity of
the machine.
To Next Page
Loading...
