Rapid Shape Operating Instructions
• Do not position the machine near heating.
• Do not expose the machine to direct sunlight.
• Do not operate the machine in damp rooms.
• Only use the machine in temperate climates and not tropical climates.
• Do no place any open flames, such as candles for example, on top or near the machine.
Warning against overheating
Caution
The machine’s electrical as well as mechanical components are only configured for a certain
ambient temperature.
For this reason, the respective warnings must be observed and adhered to before commissioning and
during operation.
• Never install the machine in a cupboard or shelf unit with insufficient ventilation.
• Never cover the ventilation vents of the machine.
• Maintain a distance of at least 200mm on every side so that the generated heat can
dissipate.
Warnings against dangerous substances
Warning
Chemicals required for the manufacture, maintenance and care must be handled correctly
and under observance of the relevant regulations and instructions for use applicable to
them.
For this reason, the handling of these chemicals must be carried out properly and in compliance with the
applicable regulations and instructions for use. The manufacturer’s specifications must be observed.
• Read the safety data sheet of the manufacturer!
• It’s recommended to wear suitable protective clothing. (UV protection goggles,
protective gloves, if necessary other protective clothing)
• The metering stipulations of the manufacturer must be observed.
Warning against harmful vapors
Warning
The materials used for printing can emit vapors which irritate the respiratory paths and/or
can lead to dizziness.
For this reason, when working with the printing materials, respective protective clothing must be worn.
A sufficient fresh air supply has to be assured.
To Next Page
Loading...
Need help?
General
