Display indication
In order to avoid unnecessary power consumption,
the intensity of indications is automatically reduced
in 2 stages during routine operation.
After 10 minutes there is an initial reduction in
indication intensity. After a further 10 minutes
indication intensity is again reduced As soon as you
touch the display or open the cooking cabinet door
indication intensity automatically returns to normal.
If your unit is switched on for longer than
20 minutes and neither a cooking mode nor
CleanJet
®
is selected, the energy saver circuit
activates automatically and only the current time
of day and the date are shown on the display
Gas appliances only
• If your appliance is installed under an extractor
hood, this must be switched on when the
appliance is in use.
• If your appliance is connected to a chimney, the
flue duct must be cleaned in compliance with
specific regional regulations. Contact your
installer
• Do not put objects on your appliance exhaust
pipes.
• The appliance must only be used in still
conditions.
Loading/removal
Open appliance door slowly.
When it is opened heating and fan wheel shut
down automatically.
The integral fan wheel brake is activated. The fan
wheel keeps running for a brief period only. Do not
touch the fan wheel.
Do not insert containers or grids until the grid shelf
has been properly secured and the mobile oven
rack has been pushed up to the stop and locked in
place.
Only use genuine heatproof accessories made by
the appliance manufacturer.
Appliances with grid shelves (6x1/1 GN,
6x2/1 GN, 10x1/1 GN, 10x2/1 GN)
Removal
Slightly raise grid shelf and lift out of front catch.
Swivel grid shelf to middle of cooking cabinet.
Press grid shelf upwards, lift from fixings. Slot into
place in reverse order.
- 7 -
General Instructions / For Your Safety
To Next Page
Loading...
