Operation QUANTRON-A 4
76
LIN bus example
1. Open the System / Test > Test/diagnosis menu.
2. Highlight the Linbus menu item.
3. Press the Enter key.
The actuator/sensor status is displayed.
Figure 4.27: Test/diagnosis, example: Linbus
[1] Status display
[2] Start self-test
[3] Connected actuators
LIN bus participant status notification
The actuators are in different states:
0 = OK; no actuator error
2 = blockage
4 = overload
n CAUTION
Risk of injury due to moving machine parts.
During the tests, machine parts may start to move automatically.
Before carrying out the test, ensure that nobody is present
in the danger zone of the machine.
3
1
2
To Next Page
Loading...