Chapter 3
22 Miller Nitro 2000 Series AutoBoom™ Installation Manual
Connect the Controller
FIGURE 11. Controller Connectors
1. Route the controller cable (P/N 115-0230-002) into the right side of the machine’s cab.
2. Locate the two controller connectors and connect them to the AutoBoom controller (P/N 063-0130-011).
Note: The AutoBoom controller should be mounted in the machine’s cab so that the machine operator
has easy access to it.
Connect the Power Leads
1. Locate the power cable that has the power and ground leads at one end.
2. Disconnect the machine’s connectors from the battery terminals.
3. Install the power lead on the positive battery terminal and reinstall the machine’s battery connector.
4. Install the ground lead on the negative battery terminal and reinstall the machine’s battery connector.
To Next Page
Loading...
