Chapter 4
32 Miller Nitro 2000 Series AutoBoom™ Installation Manual
Important: Tip the AutoBoom valve on its side and use the Allen wrench to remove the orifice from the cavity,
taking care not to let the fitting fall into the valve.
FIGURE 6. Port Plug Reinstalled on the AutoBoom Valve
5. Use the Allen wrench to reinstall the port plugs on Ports 3A and 3B of the AutoBoom valve.
FIGURE 7. Coil Reinstalled on the AutoBoom Valve
6. Reinstall the coils on the solenoids of the AutoBoom valve.
Install Fittings on the AutoBoom Valve
Before mounting the AutoBoom valve (P/N 063-0131-124) on the machine, install the proper fittings on the
valve. This prepares the valve for installation and simplifies the hose connection process later in the procedure.
Refer to the following table to install the fittings in the appropriate ports of the AutoBoom valve.
Fitting Part Number Port
Fitting - 11/16” ORFS (M) to 9/16” SAE O-Ring (M) Straight Adapter 333-0012-084 LC, RC
Fitting - 13/16” ORFS (M) to 3/4” SAE O-Ring (M) Straight Adapter 333-0012-168 P, T
Fitting - 11/16” Hex 9/16” SAE O-Ring Plug 333-0012-194 LV, RV
To Next Page
Loading...
