Chapter 5
66 Miller Nitro 2000 Series AutoBoom™ Installation Manual
FIGURE 10. Installed Boom Sensors
11. Mount the sensor bracket on the left boom using two 3-1/16” W x 4” L x 3/8” thread U-bolts (P/N 107-0171-
608) and four 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).
12. Tighten the nuts to ensure the sensor is mounted securely.
13. Repeat the steps above to mount the remaining boom sensor(s).
Mount the Center Rack Sensor
FIGURE 11. Center Rack Sensor Mounting
Outer Sensor
Inner Sensor
Dual Sensor Mounting Locations
90’ - 100’ Booms
120’ Booms
To Next Page
Loading...
