4
Manual No. 016-0230-004 Rev. F 35
PowerGlide Plus
Install the Pressure and Tank Hoses - Older Hydraulic Valves
FIGURE 11. Pressure and Tank Hoses Installed on the Machine’s Hydraulic Valve
1. Locate and disconnect the pressure hose from the right side of the machine’s hydraulic valve.
2. If the machine’s pressure hose end is 11/16”, remove the fitting from the pressure port of the machine’s
hydraulic valve and install a 13/16” ORFS (M) to 3/4” SAE O-ring (M) straight adapter fitting (P/N 333-0012-
168) in the machine’s pressure port.
3. Install a 13/16” ORFS M/M/F swivel run tee fitting (P/N 333-0012-028) in the pressure port of the machine’s
hydraulic valve.
4. If the machine’s pressure hose end is 11/16”, install a 13/16” ORFS (F) to 11/16” ORFS (M) reducer fitting
(P/N 333-0012-115) in the straight end of the installed tee fitting.
5. Connect the machine’s pressure hose to the straight end of the installed tee fitting.
WARNING
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic
fluid within the machine’s system may be
extremely hot and under high pressure.
CAUTION
When installing AutoBoom hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to
prevent any foreign material or contaminants
from being introduced into the machine’s
hydraulic system.
Objects or materials that are able to bypass the
machine’s hydraulic filtration system will reduce
performance and possibly damage the
AutoBoom hydraulic valve.
To Next Page
Loading...
