Rayonex Rayocomp PS 10 - Menu Item F1

4.3 Menu Item “F1“ Page 25
4.3 Menu Item “F1“
4.3.1 Basics Concerning the Use of Integrated Programs
When the Rayocomp devices were first introduced in 1993, it was possible to
set groups of fundamental frequency values – the harmonising programs –
automatically at last. The first Rayocomp PS 1000 devices already had 51
integrated harmonising programs. Later on, three further programs were
added, their validity remains to this very day. For example, if such a program
consists of 100 different fundamental frequency values, the Rayocomp PS 10
sets one fundamental frequency value exactly 100 times.
Due to their simple application, the harmonising programs integrated in the
Rayocomp devices are the ideal means for utilising the potential of many
thousands of individual measurements, because the harmonising programs
contain the resonance values frequently found in a certain regulation area.
For example, if you test many individuals with liver problems, the
comparison of the so-found resonance spots comes up with conspicuous
incidences; this discovery finally lead to the development of the control plan.
The set-up within the harmonising programs always follows the same
pattern. The first fundamental frequency values are the pre-control values
taken from the control plan. Then the programs receive the fundamental
frequency values on the physical level as well as pathological fundamental
frequency values of the corresponding organ. These are concluded by a value
(21.50) to stabilise the body polarities.
In practice, the course of the use of the integrated harmonising programmes
will be that based upon a diagnosis made, e.g. based upon the results of a
check-up test (see Chapter 4.4.4), the organs that are the most affected ones
can be harmonised by means of the integrated programme.
Sure enough you can use the classical therapy programs of the bio-resonance
according to Paul Schmidt with the Rayocomp PS 10 devices, but now we
have a brand new addition – the harmonising programs of the new Rayonex
Analysis and Harmonising System (RAH) in the menu item F1. This requires a
special hardware in your device. If your Rayocomp PS 10 bears the inscription
Evolution on the side, this new hardware is already integrated in the device.
For a detailed description of the utilisation of the new RAH system, look into
chapter 4.3.5.