4.5.4 Pre-Setting the Test Range Values Page 52
As soon as this has been confirmed with the OK-key, the step length can be
pre-set, perhaps to a smaller value of 0.25. As always, the step length is
confirmed with the OK-key.
Here is the standard setup of the Rayocomp PS 10 on delivery:
Initial value: 00.00
Final value: 99.99
Step length: 00.50
4.5.5 The pre-setting of the harmonisation time for fundamental
frequency values
Setup Number: 14
The pre-setting of the harmonisation time for fundamental frequency values
can be very helpful for the use of a BnPS-F1 programme, as well as for the
use of a Rayonex ‘Green Card’. If, e.g., single frequencies and also RAH-
programmes were stored on an RAH ‘Green Card’, the individual
harmonisation times for the RAH-programmes can be stored, but not for the
single frequencies. If an automatic programme sequence is started by the
means of an RAH ‘Green Card’, the default for the single frequencies can be
regulated by the pre-setting of the harmonisation time. Standard is 30
seconds. If the harmonisation time has been changed in this setup item to,
e.g., 1 minute, every existing fundamental frequency value of the Rayocomp
PS 10 is automatically harmonised with 1 minute, when using a RAH ‘Green
Card’.
In the same way, when using the BnPS Programmes, the pre-set
harmonisation time of this setup item will be used.
After selecting setup-number 14, you
confirm it with the key OK. Then the
display shows the illustration, as
demonstrated here on the left.
00.30 means 00 minutes and 30
seconds. At first, the cursor blinks in
the input-box of the minutes. For
example, you can enter 0100 and
confirm this with the key OK, and so
1 minute is pre-set.
The entry 0040 would mean a pre-setting of 40 seconds.
To Next Page
Loading...
