Rayonex Rayocomp PS 10 - Testing with Memory Card Values; Testing with Integrated Programs

4.4.1 Testing Range Values Page 38
Another possibility is to transfer the frequencies by means of the large
surface detector, maybe while sleeping at night.
And this is the method for performing the range value test:
Select the menu item “Test“ with the key .
According to the table (Chapter 4.4), enter the number 01 and confirm the
input with the OK-key. You will see the start value of the test on your display.
If you have made the right choice, please confirm with the OK-key. After
this, the concluding value is displayed, which is confirmed with the OK-key
once again. Now you have the chance to alter the step lengths or to confirm
the indicated length with the OK-key. We recommend the start value 0.00,
the final value 99.99 and a step length of 0.50. With this set-up, 200 values
will be tested. Now you can follow the description for testing fundamental
frequency values to find resonances.
4.4.2 Testing with Memory Card Values
With the Rayocomp PS 10, it is very easy to save fundamental frequency
values on a memory card. The values stored on the card can be used for
harmonisation via menu item “F1”. The values on the card can also be used
for testing. And this is the way it works:
Select the menu item “Test“ with the key .
Now insert the memory card and, according to the table (Chapter 4.4), enter
the number 02. The Rayocomp PS 10 reads in the values from the memory
card and changes over to the test mode as described before.
4.4.3 Testing with Integrated Programs
The memory cards represent individual compilations of fundamental
frequency values, but you can also test with the programs integrated in your
Rayocomp PS 10. One example: if the programs of the acupuncture
oscillation therapy are integrated in your Rayocomp PS 10, you can test a
complete channel, for instance the kidney channel.
Simply carry out the following steps:
Select the menu item “Test“ with the key .