4.4.6 RAH Module 10: Test with integrated test protocols Page 44
4.4.6 RAH Module 10: Test with integrated test protocols
The idea of the test protocols was born in the “Heilpraktikerschule der Paul-
Schmidt-Akademie”. There, you can learn among other things, which organ
structures and regulation ranges you have to consider regarding the
respective disease. This is also valid for energetic testings by means of RAH.
For example, in the case of hypertension, you have to necessarily consider
the kidney, as it produces the enzyme renin, which increases the blood
pressure. The hormonal system is important too, as it has a big influence on
the metabolism and the blood pressure. The new analysis support considers
exactly these coherences. For example, if you select the frequency structure
of the RAH-programme 39.60 hypertension, all RAH-programmes that are
linked up with the disease pattern, will be recommended to you directly for
the testing at the push of one button. Sometimes, this can be more than 100
different RAH-programmes.
An RAH-programme with an available test protocol is marked with a 10 (fig.
1) on the right of the display.
This shows immediately that a test
protocol is available. The test protocol
itself is activated by pressing the key
The display then changes to the RAH-
programmes of the test protocol. You
can leave the test protocol again by
pressing the Stop key.
1
A check mark will appear behind the
10 on the display (fig. 5), after
activating the test protocol. Then, the
current test protocol is shown. In the
middle of the display, the number of
the test protocol is indicated (fig. 2).
In this case 39.60. The figures 3 and
4 show, that the current RAH-
programme 00.00 is the first of a
total of 53 RAH-programmes. As
already described in chapter 4.4.5, all
respective RAH-programmes can now
be tested and stored.
Please also read the chapter:
4.4.8 Important tips and tricks for testing with the RAH-Module 10
2 3 4 5
To Next Page
Loading...
