4.4.5 RAH Module 10: Level test Page 43
On the left of the display it is now
shown, that there are further detail
programmes (fig. 1) under the
programme 04.20; visible via the 3
(i.e. for the third detail level).
If the sensor button is pushed forward,
the device selects the first detail
programme 04.21 (fig. 2). Now, the
display shows:
The RAH-programme 04.21 is the first
of 7 detail programmes under the
RAH-programme 04.20, which can be
found itself under the main group
04.00.
The whole structure of the RAH-
programmes can be analysed with the
Rayocomp PS 10 as described in this
chapter and – in case there is any need
for harmonisation – can be stored. You
can either first choose a main level, or
start right in the middle. If you had selected right in the beginning RAH
number 04.21, the display would have shown you the same.
Very Important:
Please also read the chapter:
4.4.8 Important tips and tricks for testing with the RAH-Module 10
These listed additional handling advices will faciliate your use of the module
10!
1
2
To Next Page
Loading...
