4.4.3 Testing with Integrated Programs Page 39
According to the table (Chapter 4.4), enter the number 03 and confirm the
input with the OK-key.Then you can choose the program you want to test. In
this special case, enter 2.08 for the kidney channel (compare chapter 5.3).
Now you can test the fundamental frequency values belonging to this
channel.
Don’t forget: Only programs activated as a module can be tested. If the
module for the acupuncture oscillation therapy is not activated, you cannot
test with the programs belonging to the module.
4.4.4 Testing with Integrated Test Programs
In addition to the integrated programs, the device also contains a
compilation of test programs which are very frequently required. They are
listed below once more for your convenience.
Display Program name
P 04 Electro-magnetic pollution test
P 05 Geopathy test
P 06 Check-up test
P 07 Bacteria and viruses test
P 08 Parasite test
P 09 Acid-base test
P 10 Quick test of the 14 channels
P 11 Vital substance test
Taking electro-magnetic pollution as an example, you test as follows:
Select the menu item “Test“ with the key .
Then enter the number 04 and confirm your entry with the OK
key. You will
receive the six most important fundamental frequency values for testing
electro-magnetic pollution.
Of course, the test programs 04 to 10 can only be used if the corresponding
module 6 (compare chapter 5.7) is activated in your Rayocomp PS 10.
To Next Page
Loading...
