5.7 Summary of the Possible Error Messages Page 68
5.7 Summary of the Possible Error Messages
No. Description
11 Wrong memory card type
12 Invalid memory card
13 No card inserted
14 Harmonising time must be at least 1 second
15 This setup item is vacant
16 Invalid module enabling code
17 Card initialising is faulty
18 Final value must be larger than initial value
19
Limit switch is faulty
If this is a frequently occurring malfunction, the device must be sent in.
20
Faulty motor contact
If this is a frequently occurring malfunction, the device must be sent in.
21
It is not possible to adjust the zero-position correctly.
If this is a frequently occurring malfunction, the device must be sent in.
22 Card is write-protected
23 Module is not activated
24 Number of selected resonance values is too large for the card
25 It is not possible to provide read and write protection for this card
26 Maximum capacity of the memory full
27 This module has already been enabled temporarily
28 No ‘Green Card’ inserted
29 Very low current! Charge battery pack!
30 Service is due
31 This program group is non-existent
32 Close current programme first by pressing the stop key twice
33 Test program is non-existent
34 Card is faulty
35 Card cannot be initialised
36 Storage values contain read-protected values which cannot be stored
37 Card was removed in storing process
38
The Polariser does not switch over to the selected mode.
If this is a frequently occurring malfunction, the device must be sent in.
39 Hardware error of the RAH module
40 Please remove the card from the card slot
41 This RAH program can only be called up with module 9 respectively 10
42 More than 200 RAH-programmes were selected
43 Double value
44 Problem occurrence when writing one value
45 Reading from the ‘Green Card’ only works beginning from module 9
46 Limitation of up to 200 RAH - programmes
47 This programme doesn’t existe. An up-date is advisable
54 Selected programme number is non-existent (see program list)
To Next Page
Loading...
