With VCRs: Setting the VCR1 Channel
The VCR1 Channel works with the VCR1 button on the remote. If the VCR1 Channel is set,pressing the VCR1 button
turns on the TV and VCR and tunes the TV to seethe VCR signal. The VCR1 setting depends on how you have the VCR
connected. If you have the VCR connected to the VIDEO INPUT, select channel 00. If you have the VCR connected to the
ANT/CABLE IN connector, select channel 3 or 4--the one selected with the channel 3 or 4 switch on the back of the VCR.
1,. Select the Setup Menu
A. Press rv to set the remote to control the
TV.
B. Press MENU to select the Setup menu.
This menu is white.
Controls Alarm Ad
13
2. Highlight VCR1 Channel
A. Press CHANNEL down to highlight the
VCR1 Channel.
B. Press + to highlight the channel.
Controls Alarm Ad
13
3. Enter channel number
Enter channel 00, 03, or 04. Press CHANNEL
down until "Disabled" is displayed to turn the
feature off.
Controls Alarm Ad
13
4. Press DISPLAY or DONE
Press DISPLAY or DONE to remove the menu
from the screen.
9
To Next Page
Loading...
